Extend-A-Mirror Kit, 2 Plastic Blocks, 2 Bars

Extend-A-Mirror Kit 1980-1997 Ford F-Series and Bronco

Includes Two Plastic Blocks and Two Aluminum Bars

Arm Measurement: 8" Long x 1" Wide x 1/4" Thick, 5/16" Hole Size

Block Measures: 2 1/4" x 1 1/2" x 1 1/2" 

• Gives 5-1/2" more vision.
• Fits most 2-point low mount truck mirror

Mounting Instructions

1. Remove mirror head
2. Position Head Extender bracket (without knob) on front side of mirror support.  1980 and newer vehicles require the supplied shim.  
3. Outside edge of bracket should barely cover original hole.
4. Slide 8" aluminum extension arm into bracket with the hole pointing away from vehicle.
5. Position other half of Head Extender bracket on rear side of mirror support and install cap screws.  
6. Re-install mirror head to extension.  
7. Adjust to desired position.

For Ford and some Toyota and Dodge, after market mirrors.  If loose, add shim.

Warning:  Improper installation of head extender wand/or failure to follow instructions may result in damage to paint.  Be sure to adjust so Head Extender does not touch paint.

 

For a Single Plastic Extend-A-Mirror Block see Item Id # 23-0173-1
For a Pair of Plastic Extend-A-Mirror Blocks see Item Id # 23-0173-2 

For 1 Extend-A-Mirror Replacement Arm see Item # 23-0173-BAR

For the Extend-A-Mirror Kit, 2 Blocks, 2 Bars see Item # 23-0173-KIT